AIFILTECH Ceramic Fiber Custom Shaped Parts

Custom Made to drawing
Temp rating 1050~1400 °C
Conductivity Low

Product Introduction

Ceramic fiber special shaped parts are vacuum-formed from ceramic fiber and inorganic binders, custom-made to drawings as curved tubes, cones, rings and drilled blocks for burner blocks, sight ports, furnace door seals and other hot spots.

Specifications

FeaturesCustom-formed to drawing
CustomYes
BrandAIFILTECH
Material陶瓷纤维+无机结合剂
Temperature1050-1400 ℃
工艺真空成型
Density260-450 kg/m³
交期开模后 15-25 天

Detailed Overview

01 Product Overview

Shaped parts are produced by vacuum forming: mixed ceramic fiber slurry is dewatered in custom molds, then dried and fired. The parts have accurate dimensions, a hardened surface and higher strength than blankets, with pre-formed holes and grooves for direct installation at complex locations and less on-site waste.

02 Performance & Mechanism

The parts retain a porous fiber skeleton with high porosity and low thermal conductivity, while a densified skin improves resistance to hot gas erosion and splash, keeping shape and insulation performance under direct high-velocity hot gas impingement.

03 Advantages

  • Custom-made to drawings with high shape complexity; 2. Accurate dimensions with pre-formed holes and grooves; 3. Densified skin resists erosion and splash; 4. Low conductivity and heat storage, replacing heavy refractories; 5. Low tooling cost, flexible for small and medium batches.

04 Applications

Used for burner blocks, sight-port preforms, furnace door seals, aluminum launder insulation and exhaust heat shield linings. Tooling from drawings, sample confirmation and batch delivery are available.

Sizing & selection Q&A

How is the grade chosen?

These parts are ceramic fibre with an inorganic binder, rated 1050-1400 °C; the mix can be adjusted within the same tooling. Where chlorides or sulphur are present, the binder system is checked before the grade is fixed.

Are non-standard sizes possible?

Yes. Parts are vacuum-formed or machined to drawing, with wall thickness, hole pattern and tolerance agreed before the tool is cut.

Do you accept small batches?

Lead time is 15-25 days after the tool is opened. Small batches are fine, and stock sizes ship from shelf.

Is a trial batch possible?

A trial batch on your equipment is the normal route; the data is signed off before volume.

Applications

Burner blocks Sight ports Furnace door seals Custom

All data above are obtained under specific test conditions; the actual solution must be engineered to site conditions. AIFILTECH provides custom design and sizing based on actual gas volume, temperature, dust characteristics and emission limits.

WhatsApp