AIFILTECH Sintered Metal Cartridge Dust Collector - High-Temp Metal Filter Unit

Max. Temp. 280~650℃
Rating 3~100 μm
Cartridge Washable & reusable

Product Introduction

AIFILTECH sintered metal cartridge dust collectors use multi-layer sintered wire mesh / sintered metal fiber felt cartridges rated 280-650 °C depending on material, with filtration ratings of 3-100 um. Cartridges are regenerable by back-pulsing and washing - ideal for sticky dust, oil mist carryover and low-emission hot gas duty.

Specifications

FeaturesRegenerable cartridges
CustomYes
BrandAIFILTECH
Filter elementSintered mesh / sintered fiber felt
Temperature280-650 ℃
Filtration rating3-100 μm
Porosity28%-85% (滤材而异)
CleaningPulse-jet / off-line washing

Detailed Overview

01 Product Overview

The collector consists of sintered metal cartridges, tube sheet, pulse valves, hopper and casing. Cartridges are rolled and welded from multi-layer sintered mesh or sintered metal fiber felt, with high strength against thermal stress and pulse impact. Dust cakes on the outer surface while clean gas exits the bore. The smooth, non-hygroscopic, non-sticky cartridge surface suits sticky and hygroscopic dust; plugged cartridges can be regenerated by online back-pulse or off-line washing for long service life.

02 Working Principle

Pores of multi-layer sintered mesh are formed by sintering overlaid wire layers into tortuous, graded channels - coarse outer pores pre-filter while inner layers control final rating, balancing low pressure drop with high efficiency. Sintered fiber felt cartridges offer 70-85% porosity and high dust-holding capacity; back-pulse air expands outward from the bore, stripping the cake cleanly for fast differential pressure recovery.

03 Advantages

  • Rated 280-650 °C (per stainless/FeCrAl material) for direct hot gas duty; 2. Filtration ratings 3-100 um with outlet dust controllable below 5 mg/Nm³; 3. High-strength cartridges resist thermal shock and corrosion, no static build-up; 4. Smooth non-sticky surface suits sticky, hygroscopic and oil-mist-laden dust; 5. Regenerable by back-pulsing and repeated washing for low running cost.

04 Applications

Applied to electroplating acid mist, asphalt fume, dryer exhaust, spray granulation, food/pharmaceutical dust recovery, aluminum chip conveying and hot-air recirculation filtration with sticky or oily dust. 316L/310S/FeCrAl cartridges are selected per dust properties.

Sizing & selection Q&A

What inlet temperature is allowed?

Filter media is rated to 280-650 ℃. Above the case limit the gas needs pre-cooling or tempering air, and casing and tube sheet are built for the matching band.

Can particulate stay below 10 mg/Nm³?

On normal duty, yes. With very high inlet loading or sticky dust, a pilot run sets the filtration velocity first so acceptance is not at risk.

Who handles site installation?

Site supervision can be supplied, or remote support only; civils and steel structure usually stay with the owner.

Is leak detection online?

Online leak detection locates a failed compartment during operation, avoiding a full teardown.

Applications

Sticky dust Oil mist gas Dust recovery Hot air filtration

All data above are obtained under specific test conditions; the actual solution must be engineered to site conditions. AIFILTECH provides custom design and sizing based on actual gas volume, temperature, dust characteristics and emission limits.

WhatsApp