AIFILTECH Titanium Felt for Hydrogen Production (PEM Electrolyzer PTL)

Ti Purity ≥99.5%
Surface Resistance ≤5 mΩ·cm²
Pt Coating 0.2~0.5μm

Product Introduction

Titanium felt for hydrogen production is the core porous transport layer (PTL) material of PEM water electrolyzers - high porosity, low resistance and resistant to oxygen/hydrogen evolution corrosion, in 0.25-1.0 mm thickness and 50-80% porosity for PEM and AEM stacks.

Specifications

钛纯度≥99.5% (工业纯钛)
Thickness0.2-1.0 mm (customizable)
Porosity50%-70% (梯度可调)
面电阻≤5 mΩ·cm²
孔径18-50 μm (MPL 层 100-200 μm optional)
镀层Pt 镀层 0.2-0.5 μm (optional)
透气度800-1000 L/(min·dm²) @200 Pa
最大幅面800×1500 mm (customizable)

Detailed Overview

01 Product Overview

The anode of a PEM electrolyzer operates at high potential in a strongly oxidizing oxygen-rich environment where ordinary porous materials corrode rapidly. Sintered from pure titanium fiber, the felt stays stable at high potential; its 3D interconnected pores quickly remove oxygen generated at the membrane, distribute water uniformly and collect current evenly - a key component for electrolyzer efficiency and lifetime.

02 Performance & Mechanism

Sintered titanium fiber felt gas diffusion layer (GDL/PTL) for PEM water electrolysis. The base material is ≥99.5% industrial pure titanium fiber, surface passivated for long-term service in acidic (sulfuric acid / PFSA) high-potential, high-humidity environments without oxidation or powdering. Porosity 50-70% with gradient options; optional MPL layer (100-200 μm pores) and Pt coating (0.2-0.5 μm) bring the area resistance down to ≤5 mΩ·cm2 - ensuring sufficient electrolyte wetting while venting H2/O2 quickly, reducing ohmic and mass-transport polarization.

03 Advantages

  • Pure titanium fiber, resistant to high-potential oxygen evolution; 2. 50-80% porosity for fast bubble detachment; 3. Low contact resistance reduces cell voltage and energy use; 4. 0.25-1.0 mm thickness with good compression recovery; 5. Pt/Ir noble-metal coating options for further savings.

04 Applications

For PEM electrolyzer anode/cathode PTLs, AEM stacks, laboratory and industrial electrolyzers and hydrogen refueling equipment. Custom discs, squares and coatings to stack drawings.

05 Fiber Structure

Micron titanium fibers are laid non-woven and sintered into a 3D fully-connected pore network — large contact area with the membrane and low contact resistance, the ideal structure for a PEM electrolyzer diffusion layer.

AIFILTECH titanium fiber felt microstructure

Sizing & selection Q&A

Are non-standard sizes possible?

Yes. Cut or tooled to drawing, with hole pattern, thickness and weld type as specified.

Do you accept small batches?

Small batches are fine, and stock sizes ship from shelf.

Is a trial batch possible?

A trial batch on your equipment is the normal route; the data is signed off before volume.

What do you need from me to quote?

Flow rate, temperature and gas composition, plus the installation envelope. Those three are enough for a proposal; the rest is settled at technical agreement stage.

Applications

PEM electrolyzer AEM electrolyzer Hydrogen plants Custom

All data above are obtained under specific test conditions; the actual solution must be engineered to site conditions. AIFILTECH provides custom design and sizing based on actual gas volume, temperature, dust characteristics and emission limits.

WhatsApp